The Moisture Absorption Problem of Nylon: Why Does It Become Brittle, Deformed, and Fail?

Nylon is one of the most widely used engineering plastics, valued for its strength, toughness, and wear resistance in industries such as automotive, electronics, and consumer goods. However, its molecular structure contains a large number of amide groups, which have a strong affinity for water molecules. This intrinsic feature makes nylon highly hygroscopic, and when exposed to humid environments, it readily absorbs moisture. Such moisture absorption significantly affects both mechanical properties and dimensional stability, often leading to unexpected failures.

When nylon absorbs moisture, water molecules penetrate the intermolecular spaces and form hydrogen bonds. This process weakens the original hydrogen bonding between chains and increases molecular mobility. In the short term, toughness and impact resistance may improve, but tensile strength decreases over time. In structural components, repeated cycles of swelling and shrinkage during humidity changes introduce residual stresses that can cause warpage, deformation, and cracking.

In electronics, moisture-induced dimensional changes may compromise precision, disrupt assembly tolerances, and even cause electrical contact failure. In automotive applications, nylon parts such as gears and connectors may lose strength due to water absorption, resulting in reduced fatigue life or sudden failure. Under alternating hot and cold conditions, the freezing or evaporation of absorbed water further amplifies these destructive effects.

Moisture absorption also lowers the glass transition temperature of nylon, causing it to shift from a rigid state to a softer, unstable one. For applications requiring long-term stiffness, this is highly detrimental. When the absorbed water eventually evaporates, the material becomes brittle again, concentrating stresses and promoting cracking. This alternating cycle of embrittlement and deformation makes nylon components prone to unpredictable failure in real-world conditions.

Several solutions have been developed to address nylon’s hygroscopicity. Copolymerization, such as PA6/66 copolymers or the introduction of hydrophobic monomers, can reduce the number of polar groups. Reinforcement with glass or carbon fibers helps limit swelling and improve dimensional stability. Surface coatings or barrier layers can reduce water penetration. In manufacturing, thorough drying before molding is essential to maintain low moisture content. For demanding environments, high-performance modified nylons such as PA6T or PA9T offer significantly lower water absorption due to their denser molecular structures.

Nylon’s moisture absorption issue is the combined result of its molecular structure and environmental factors. It may increase toughness in the short term but compromises strength and dimensional stability in the long run. Engineers must account for the dynamic impact of moisture and adopt suitable modification and design strategies. Only by understanding the mechanisms thoroughly can nylon components maintain reliable performance under complex operating conditions.